Bolid Signal-10 Bedienungsanleitung PDF herunterladen (Seite 39)

Signal-10 Operation Principles

39 www.bolid.com

device reader with a Master Key. For detailed description of the User Key Programming Mode, refer to

the Programming of User Keys by Hardware Section on the page 87.

Self-Diagnostic Mode

To switch the device from the standby condition to the Self-Diagnostic Mode, press tamper switch with

a specific code combination. For detailed description of the Self-Diagnostic Mode, refer to the Testing

the Signal-10 in Self-Diagnostic Mode Section on the page 90.

Device Failure Mode

When an error occurs during a microcontroller memory test, the device switches to the Device Failure

Mode. The device performs the memory test after each power-up.

When the device switches to the Device Failure Mode:

− READY LED flashes rapidly with red

− Device sounder beeps every 2s

− LEDs ‘1’ – ‘10’ are off

− The device doesn’t respond to breaking loops, pressing tamper switch, or presenting elec-

tronic keys

If the device switches to the Device Failure Mode after each power-up, update microcontroller firmware.

For the firmware update procedure, refer below:

― Forward the corresponding request to ZAO NVP Bolid (remember to specify the device ver-

sion). Our specialists will respond with dedicated software ("ORION_PROG.EXE") and an

electronic file containing the microcontroller firmware.

― Connect the device to a PC via a PI-GR or S2000-PI interface converter.

― Run ORION_PROG.EXE file and apply power to the device.

― Follow on-screen instructions and wait until the firmware update process will be completed.

During the firmware update process the device sounder silences and READY LED flashes

synchronously with receiving data packages from the PC. The firmware update procedure be-

ing completed, the device switches to the Pre-Operation Mode.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 95 96

Keine Kommentare

Bolid Signal-10 Bedienungsanleitung Seite 39