Bolid Signal-10 Bedienungsanleitung PDF herunterladen (Seite 32)

INTRUSION&FIRE ALARM ADDRESSABLE 20-LOOP CONTROL DEVICE

Parameter Description Range

Interface

Response Delay

Defines the value of delay for the

device to response for the net

controller request that has been

received through the interface

RS-485

From 1,5 ms to

500 ms in incre-

ments of 1/8 s

4.3.1 Voltage Analysis

The parameter "Voltage Analysis" defines the condition for device

transition the “Power Failed” mode, whether this condition deals with any

one input voltage trouble or both.

If this parameter is set on the device transits the “Power Failed” mode

when any input voltage has fallen below 10 V and returns back to the op-

erating mode when both input voltages have exceeded 11 V.

If this parameter is set off the device keeps the operating mode until

both input voltage had fallen below 10 V. In such a case the device transits

the “Power Failed” mode and returns back to the operating mode when at

least one input voltage has exceeded 11 V.

4.3.2 Net Address

The “Net Address” parameter is intended to uniquely identify the de-

vice when operating as a part of “Orion” safety system. In such operation

mode the device can transmit messages and receive the commands from

the net controller, being addressed only by means of this unique network

number.

4.3.3 Interface Response Delay

The “Interface Response Delay” parameter is used in case of com-

plicated net configuration taking place when the data transmission can be

delayed, e.g. in case of RS-485 interface conversion to the other interface

types designed for local network, fiber-optic or radio communications.

The current values of “Net Address” and “Interface Response De-

lay” parameters can be reset to default ones by means of three long and

one short tamper pressings. Long pressing means holding during no less

then 1,5 s. Short pressing means holding duration from 0,1 to 0,5 s. Pause

between pressings shall stretch from 0,1 up to 0,5 s.

To adjust the device for the specific application and for it more effec-

tive operating any parameter (such as loop or relay one or device setting)

can be changed by means of "UPROG.EXE" program or ARM Orion Data-

base Administrator program (see section 5.1.4).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 56 57

Kommentare zu diesen Handbüchern

Keine Kommentare

Bolid Signal-10 Bedienungsanleitung Seite 32

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Bolid Signal-10